Removing The Stitcher Mount Unit - Canon J1 Service Manual

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Stitcher Mount Unit
NOTE:
When installing the saddle unit, install so that the Mylar [1] at the front upper side of
the saddle is on the outside of the delivery guide plate [2] as shown in the figure.
Delivery fault will occur if it goes inside.
[1]
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Stitcher Mount Unit
[2]
F-4-54

Removing the Stitcher Mount Unit

1) Remove the front cover. (Refer to page 4-14)
2) Remove the front inside upper cover. (In the case of Staple Finisher, this procedure is
unnecessary.)(Refer to page 4-17)
3) Remove the front inside lower cover.(Refer to page 4-18)
4) Remove the E ring [1], shaft [2], and roller [3].
[3] [1]
5) Pull out the stitcher mount unit [1] to the front.
[1]
4-27
[2]
F-4-55
F-4-56
4-27