Canon J1 Service Manual page 114

5
Adjustment > Basic Adjustment > Function Setting Operation
6) Press PSW3 on the finisher controller PCB.
7) Press PSW1 or PSW2 on the finisher controller PCB.
-When setting is turned ON from OFF, press PSW2.
-When setting is turned OFF from ON, press PSW1.
<Display of Adjustment Value>
OFF=0, ON=1
When 1 is displayed, LED2 (2sec.) and LED3 (300ms) turn on in turn.
When 0 is displayed, LED2/3 turns on in turn for two seconds.
8) When adjustment is complete, remove paper and press PSW3 on the finisher controller
PCB once to store the adjustment in memory.
9) Turn off all bits of finisher controller PCB DSW1.
10) Turn off the power of the host machine and install the rear cover of finisher.
5
Adjustment > Basic Adjustment > Function Setting Operation
5-16
5-16