Control Connections; Drive/Inverter Control Connections; Supply Unit Control Connections - ABB ACS800 Hardware Manual

92

Control connections

Drive/inverter control connections

The control connections are made on the terminal blocks provided in the swing-out
frame in the auxiliary control cubicle of the drive. Refer to the circuit diagrams
delivered with the drive, and to the chapter

Supply unit control connections

The supply unit is controlled using the local control devices mounted on the cabinet
door. No external control connections by the user are needed. However, the user
can connect certain external devices to the supply module. It is possible to:
• halt the supply unit by an external emergency stop button (if the unit is equipped
with a local emergency stop button)
• read supply unit's status information through the relay outputs.
Refer to the circuit diagrams delivered with the drive for the connection terminals for
the external control devices.
Electrical installation
Motor control and I/O board (RMIO).