Changing The Recorder Speed; Changing The Recorder; Continuing A Timed Recording - Philips V24CT User's Reference Manual

Changing
The recording speed can be changed for delayed, realtime, and oxyCRG
the
recordings made on a bedside recorder. Changes made in the Change
Recorder
Recording Speed window affect only the last requested and running
Speed
recording.
Note—
Recording Speed window affects only the last requested and running
recording. However, if the last requested recording is stopped, the Change
Recording Speed window then affects the recording that started running
before the stopped one.
Because the recorder must complete the annotation at the beginning of
the strip before the key to access this window appears, there may be a
wait of a few seconds before the speed can be changed. For delayed
recordings, access to the Change Recording Speed window is through the
The speed of alarm recordings cannot be changed; these recordings
always run at 25 mm/sec.
Changing
You can change the recorder where alarm, delayed, preset, or realtime
the
non-configured recordings are made.
Recorder
Continuing
Press
a Timed
pressing the
Recording
the display).
If more than one bedside recording is running, the Change
key. The new speed is not stored.
Realtime Record
1. Press
Monitor Setup
2. Press Recordng Setup
3. Select the recording type (Delayed & Alarm, Mode, or Procedure).
4. Press Change Recorder
on the recorder. The recording runs until you stop it (by
CONT
on the recorder or the
STOP
.
.
to choose the appropriate recorder.
Stop Recordng
Additional Information
softkey on
Recording Functions 6-43