Chapter 2 Hardware Descriptions; System Cabinets - Samsung iDCS500 Manual

2
Chapter
This chapter describes the hardware of the iDCS 500 system as follows.

System Cabinets

Common Control Cards
Interface Cards
Station Equipment
SYSTEM CABINETS
The cabinets that make up the iDCS 500 system are of metal construction and may be utilized as either
as an expansion cabinet or as a main cabinet / key service unit (KSU). The cabinets may be used
singly or may be stacked up to three (3) high to achieve maximum capacity. A single cabinet may be
wall mounted for smaller applications or alternatively the system may be mounted in a standard
nineteen inch (19") equipment rack after removal of the side panels and their supporting brackets.
Each cabinet is comprised of the following:
Eight interface card slots
One dual purpose interface card / signal processor slot (see 'Size and Configuration' section.)
One processor card slot
Two power supply slots
One IOM board slot for use when the cabinet is the main cabinet/KSU (see 'IOM Board' section)
AC power connector
DC power (Battery Backup) connector
NOTE: The first power supply slot must be occupied by a PSU-B power supply to supply sufficient
power to all 10 slots (8 interface, one dual purpose and one processor slot). The second power
supply slot can be occupied by either a PSU 60 or a PSU-B. Do not install a PSU 40 in any PSU slot.
Hardware Descriptions
2-1