Caller Id Code Set - Panasonic KX-TD816 Programming Manual

2.2 System Programming

[110] Caller ID Code Set

Description
Sets the identification code of the calling party (Caller ID Code) to utilise a Caller ID Service
provided by a specific central office (CO). If an ID Code transmitted from the CO is found in
the Caller ID Code Table, the caller's ID Code or name given to the code in programme
[111] Caller ID Name Set is displayed on the telephone. This allows the called party to
recognise the caller.
Selection
• Location number: 001 through 500
• Caller ID Code: 24 digits (max.)
Default
All locations – Not stored
Programming
1.
Enter 110.
Display: 110 CALLER ID #
2.
Press NEXT.
Display: Location NO?
3.
Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: 001:Not Stored
4.
Enter a Caller ID Code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new code.
5.
Press STORE.
6.
To programme another location, press NEXT or PREV, or SELECT and the desired
location number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• Each Caller ID Code has a maximum of 24 digits, consisting of 0 through 9.
• Programme [111] Caller ID Name Set is used to give names to the Caller ID Codes. If an
ID Code is assigned a name, the called party's telephone will show the name in place of the
ID Code.
70 General Programming