Memory Module Structure; Replacing A Memory Module - HP HSR6800 Installation Manual

For the memory module specifications, see

Memory module structure

Figure 72 Memory module structure (DDR2)
(1) Connector edge
(3) Latch notch
Figure 73 Memory module structure (DDR3)
(1) Connector edge
(3) Latch notch

Replacing a memory module

The methods for replacing memory modules are similar. This example replaces a memory module on an
RSE-X2.
To replace a memory module:
1. Pull the release latches away from the memory module at both ends so that the memory module is
lifted from the memory module slot.
2. Holding the non-conductive edge, remove the memory module.
3. Align the polarization notch of the memory module with the key in the connector.
4. Insert the memory module into the slot.
"Appendix A Chassis views and technical
(2) Polarization notch
(2) Polarization notch
54
specifications."