Item
Memory type and size
NVRAM
Combo interface
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
•
For a combo interface, the default operating port is the copper port. You can use either the copper port
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
HP HSR6800 Routers Interface Command Reference
see
Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with
•
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-210 combo interface specifications
Specification of combo interfaces on the FIP-210 and the FIP- 1 10 are the same. For more information,
see
Table 34
Transceiver modules for the FIP-210 and for the FIP- 1 10 fiber ports are the same. For more information,
see
Table
36.
Maximum interface modules provided by FIP-210 in full configuration
FIP/Interface
module
FIP-210
MIM
HIM
FIP-300
The FIP-300 supports HIMs and MIMs, and it provides 12 combo interfaces.
Remarks
•
Default—Two 1-GB DDR2 SDRAMs
•
Maximum—Two 2-GB DDR2 SDRAMs
128 KB
2
2 copper ports (MDI/MDIX
autosensing)
2 fiber ports
2 supported
2 supported
Supported
Supported
and
Table
35.
HSR6802
2
4
4
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
.
HSR6804
4
8
8
98
HSR6808
8
16
16