FIP-300 front panel
Figure 93 FIP-300 front panel
(1) HIM/MIM slot
(3) GE0 through GE11 fiber ports
FIP-300 specifications
Item
Flash
Memory type and size
NVRAM
Combo interface
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
For a combo interface, the default operating port is the copper port. You can use either the copper port
•
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
HP HSR6800 Routers Interface Command Reference
see
Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with
•
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-300 combo interface specifications
Specification of combo interfaces on the FIP-300 is the same as FIP- 1 10. For more information, see
34
and
Table
Transceiver modules for the FIP-300 are the same as the FIP- 1 10. For more information, see
Remarks
8 MB
•
Default—Two 2-GB DDR3 SDRAMs
•
Maximum—Two 2-GB DDR3 SDRAMs
128 KB
12
Copper ports (MDI/MDIX
autosensing)
Fiber ports
1 supported
1 supported
Supported
Supported
35.
(2) GE0 through GE11 copper ports
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
.
99
Table
Table
36.