HP HSR6800 Installation Manual page 107

Item
Hot swapping
NOTE:
For a combo interface, the default operating port is the copper port. You can use either the copper port
•
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
HP HSR6800 Routers Interface Command Reference
see
• Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-310 combo interface specifications
Specification of combo interfaces on the FIP-310 is the same as FIP- 1 10. For more information, see
34 and Table
Transceiver modules for the FIP-310 are the same as the FIP- 1 10. For more information, see
FIP-310 10 Gbps Ethernet port specifications
Table 37 FIP-310 10 Gbps Ethernet port specifications
Specification
Connector type
Transceiver module type
Interface standards
Transmission
power
Receive sensitivity
Central wavelength
Fiber type
Operating mode
Maximum interface modules provided by FIP-310 in full configuration
FIP/Interface module
FIP-310
Remarks
Supported
35.
Description
LC
SFP+
802.3ae
Short-haul
Type multi-mode
(850 nm)
Minimum –7.3 dBm
Maximum –1 dBm
–7.5 dBm
850 nm
50/125 μm
and
65.5/125
μm
multi-mode
fiber
10 Gbps (full duplex)
SR6604-X
2
.
Mid-haul
Long haul
single-mode
(1310 nm)
(1310 nm)
–6.5 dBm –8.2 dBm
0.5 dBm 0.5 dBm
–6.5 dBm –10.3 dBm
1310 nm 1310 nm
50/125 μm
and 9/125 μm
65.5/125 μm single-mode
multi-mode fiber
fiber
SR6608-X
4
101
Table 36.
Super long
Long haul
haul (1550
(1550 nm)
nm)
–4.7 dBm 0 dBm
4 dBm 4 dBm
–11.3 dBm –24 dBm
1550 nm 1550 nm
9/125 μm 9/125 μm
single-mode single-mode
fiber fiber
SR6616-X
8
Table