Humidity; Altitude; Cleanness - HP HSR6800 Installation Manual

Table 2 Temperature requirements
Item
Operating temperature
Storage temperature

Humidity

Maintain appropriate humidity in your equipment room, as described in
Lasting high relative humidity tends to cause poor insulation, electricity creepage, mechanical
•
property change of materials, and corrosion of metal parts.
Lasting low relative humidity is likely to result in loose screws due to washer contraction, and even
•
ESD, which causes the circuits to fail.
Table 3 Humidity requirements
Item
Operating humidity (noncondensing)
Storage humidity (noncondensing)

Altitude

Table 4 Altitude requirements
Item
Operating altitude
Storage altitude

Cleanness

Dust buildup on the chassis might result in electrostatic adsorption, which causes poor contact of metal
components and contact points, especially when indoor relative humidity is low. In the worst case,
electrostatic adsorption can cause communication failure.
Table 5 Dust concentration limit in the equipment room
Substance
Dust particles
NOTE:
Dust particle diameter ≥ 5 μm
The equipment room must also meet strict limits on salts, acids, and sulfides to eliminate corrosion and
premature aging of components, as shown in
Temperature
0°C to 45°C (32°F to 113°F)
–40°C to +70°C (–40°F to +158°F)
Humidity
10% to 95%
5% to 95%
Altitude
–60 m (–196.85 ft) to 4 km (2.49 miles)
–60 m (–196.85 ft) to 4.5 km (2.80 miles)
Concentration limit (particles/m
≤ 3 x 10 4
(No visible dust on desk in three days)
Table 6.
5
Table 3.
3 )