Cannot Load Sheets; Paper Is Not Cut Neatly; Paper Is Not Cut; Depression On The Leading Edge Is Left - Canon imagePROGRAF iPF6400SE User Manual

Cannot load sheets

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly

The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before
it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
Cut Speed is not configured correctly in the Con-
trol Panel menu.
During cutting, printed documents fall out at an
angle.

Paper is not cut

Paper is not cut

The printed document became caught on a foreign object by the
Output Tray, which lifted the document. The Cutter passed un-
der the paper.
In the printer driver, No or Print Cut Guideline is specified in
Automatic Cutting.
In the Control Panel menu, Cutting Mode is set to Eject or
Manual.

Depression on the leading edge is left

Depression on the leading edge is left

Keeping a roll in the printer for a long time
without printing on it may leave a depression
on the leading edge.

Margins are wide

Margins are wide

Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
When Cutting Mode in the Control Panel menu was
set to Manual, you selected Do not perform in re-
sponse to the "Perform the detection of paper lead-
ing edge?" message.
618
Press the Load button and select the paper source.
Cause
Cause
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to On
or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Cause
Corrective Action
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
P.469
➔
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Remove the foreign object by the Output Tray to enable the printer to
eject the printed document, keeping it level.
Specify Yes in Automatic Cutting in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
P.469
➔
This operation is normal.
Set Cutting Mode to Manual again, and select Perform(recommend) when
the "Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly
curled, the Printhead may rub against the leading edge of the paper when the
printing starts.
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
P.376
➔
P.376
➔
Corrective Action
Corrective Action
P.376
➔
iPF6400SE
User's Guide