Toro Greensmaster 3150 Service Manual page 82

Removal (Fig. 28)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, engage parking
brake, lower cutting units, and stop engine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
2. Remove reel motor from the cutting unit (see Chap-
ters 7, 8, 9, or 10 – Cutting Units in this manual).
Note: The position of hydraulic fittings on the reel mo-
tor is critical to properly reconnecting hydraulic hoses.
3. Label all hose connections for reassembly pur-
poses. Matchmark reel motor and all hydraulic fittings
for reassembly purposes.
4. Remove hose connections from the hydraulic fit-
tings on the reel motor. Allow hydraulic oil to drain from
hoses into a suitable container. Put caps or plugs on
ends of hoses to prevent contamination.
5. Remove hydraulic fittings and O–rings from the reel
motor. Put caps or plugs in motor openings to prevent
contamination.
Hydraulic System
Installation (Fig. 28)
1. Inspect threads and sealing surfaces of fittings. Re-
place any worn or damaged fittings.
2. Apply clean hydraulic oil to all O–rings.
3. Place O–ring on the face seal of a hydraulic fitting.
Secure fitting to the reel motor. Make sure that the match
marks are aligned. Repeat this step for the remaining fit-
tings.
4. Inspect threads and sealing surfaces of connec-
tions. Replace any worn or damaged connections.
5. Install reel motor to the cutting unit (see Cutting Unit
Removal and Installation in Chapter 7– Cutting Units).
6. Secure hose connection to the proper hydraulic fit-
ting on the reel motor. Repeat this step for the remaining
hose connections.
Page 4 – 58 Greensmaster 3150