Toro Greensmaster 3150 Service Manual page 228

Bearing and Seal Installer (TOR4105)
Used to install bearings and seals into front and rear roll-
ers that have a threaded roller shaft.
NOTE: TOR4105 is an alternative to using washers
and spacers listed above.
Inner Grease Seal Installation Washer
Inner grease seal installation washer Toro Part Number
104-0532
This washer is used when replacing the reel bearing in-
ner grease seal. It enables pressing the grease seal to
a depth of .104 in. (2.64 mm) below the surface of the
cutting unit side plate.
Toro Part Number: 104-0532
Plastic Plug
This cap is used for placement into the bearing housing
when the reel motor is removed. It prevents dirt and de-
bris from entering the housing.
Toro Part Number: 2410–30
Turf Evaluator Tool
Many turf discrepancies are subtle and require closer
examination. In these instances, the Turf Evaluator
grass viewing tool is helpful. It can assist turf managers
and service technicians in determining causes for poor
reel mower performance and in comparing the effective
height–of–cut of one mowed surface to another. This
tool should be used with the Toro Guide to Evaluation
Reel Mower Performance and Using the TurfEvaluator
(Toro part no. 97931SL)
Toro Model Number: 04399
Dual Point Adjust Cutting Units
Page 10 - 4 Rev. A
Figure 6
Figure 7
Figure 8
Figure 9
Greensmaster 3150