Table of Contents
Advertisement
9. Install wheel and tire assembly. Torque wheel nuts to
45–55 ft–lbs.
10. Repeat procedure on left side of machine.
Note: Install drive shaft to traction unit before installing
left wheel and tire assembly.
11. Slide drive shaft onto traction unit PTO shaft. Align
mounting holes in each shaft and slide together.
12. Secure with roll pin and (2) capscrews and nuts.
Install Castor Wheel
Assemblies
The castor wheel assemblies are installed upside down on
the debris blower for shipping.
1. Remove tensioning caps from spindle shafts and slide
off castor wheel, spacers and thrust washers (Fig. 2).
2. Slide spacers onto castor spindle to get desired height.
Slide a thrust washer onto spindle, push castor spindle
through frame. Install another thrust washer and
remaining spacers onto spindle and install tensioning
cap to secure assembly.
1
2
2
Figure 2
1. Tensioning cap
2. Thrust washers
Important
Thrust washers – not the spacers – must
contact the top and bottom of the blower frame.
3
3. Spacers
4. Front castor spindle
3. Assure both castor wheels are set at same height.
Install Stand
1. Remove snapper pin securing stand to tube on blower
frame (Fig. 3).
2
Figure 3
1. Snapper pin
2. Lower stand. Re–install pin through upper set of holes
in stand and tube. Secure pin.
3. Remove snapper pin securing stand to tube on blower
frame.
4. Raise stand. Re–install pin through lower set of holes in
stand and tube. Secure pin.
5. Stand blower up on castor wheels and stand (Storage
position).
Mount Frame Mount To Blower
1. Position traction unit/frame mount in line with rear of
Debris Blower.
2. Align frame mount tubes with mounting holes in blower
frame (Fig. 4).
2
Figure 4
1. Frame mounting tube
8
1
2. Stand tube
1
2. Blower
Advertisement
Table of Contents
