Setup; Mounting The Castor Wheel - Toro 30393 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: To install and operate the debris blower, the traction
unit must be equipped with the Rear Quick Attach System,
Model 30377 and the Auxiliary Hydraulic Power Kit, Model
30380.
1

Mounting the Castor Wheel

No Parts Required
Procedure
1. Remove the tensioning cap from the castor wheel
spindle shaft (Figure 3). Slide the spacer and one thrust
washer off the spindle shaft. Leave one thrust washer
on the shaft.
Description
No parts required
Debris blower assembly
Locking pin
Hair pin cotter
No parts required
No parts required
No parts required
Qty.
–
1
1
1
–
–
–
Qty.
1 Review the manual before operating the machine.
1 Use the catalog to reference product part numbers.
1. Tensioning cap
2. Spacer
3. Thrust washer (2)
2. Push the castor spindle up through the bushings in the
blower frame, insert another thrust washer onto the
shaft, slide the spacer onto the spindle shaft and install
the tensioning cap to secure the assembly (Figure 3).
6
Use
Mount the castor wheel.
Mount the debris blower to the traction
unit.
Adjust the link assembly.
Grease the blower.
Install the front weight.
Use
Figure 3
4. Blower frame castor tube
5. Castor wheel