Media and Additional Parts
Description
Operator's Manual (traction unit)
Engine Operator's Manual (engine)
Parts Catalog
Operator Training Materials
Pre-delivery Inspection Sheet
Noise rating certificate
Certificate of compliance
Ignition keys
Note: Mounting fasteners for the Greensmaster 3250-D
cutting units are included with the cutting units.
1
Mounting the Seat
Parts needed for this procedure:
1
Seat
4
Nut (5/16 inch)
Procedure
Note: Mount the seat slides in the front set of mounting
holes to gain an additional 7.6 cm (3 inches) in the forward
adjustment, or in the rear mounting holes for an additional
7.6 cm (3 inches) in the rearward adjustment.
1. Remove the locknuts securing the seat slides to the
shipping base straps. Discard the locknuts.
2. Connect the wire harness to the seat switch.
3. Secure the seat slides to the seat support with the
locknuts (5/16 inches)
parts.
Qty.
(Figure
3) supplied in the loose
1
Read before operating the machine.
1
1
Save for future parts ordering.
1
View before operating the machine.
1
1
Save for future reference.
1
2
Use to start the engine.
1. Seat support
2
Activating and Charging the
Battery
No Parts Required
Procedure
Use only electrolyte (1.265 specific gravity) to fill battery
initially.
1. Loosen the bolt on the battery retainer, move the
retainer away from the battery and lift out the battery.
14
Use
Figure 3
2. Seat slide