Brake Maintenance; Adjusting The Parking Brake Interlock Switch - Toro 30695 Operator's Manual

Brake Maintenance

Adjusting the Parking Brake
Interlock Switch
1. Stop the machine, move the deck lift switch fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel (Figure 41).
2
1
Figure 41
1. Bolts
2. Control panel
3. Loosen the 2 jam nuts securing the parking brake
interlock switch to the mounting bracket.
Figure 42
1. Brake-shaft sensor
2. Jam nuts
G020875
3. Parking-brake-interlock
switch
4. 3.9 mm (5/32 inch )
4. Move the switch up or down on the bracket until the
distance between the brake shaft sensor and the switch
plunger is 3.9 mm (5/32 inch)
Note: Make sure that the brake-shaft sensor does not
contact the switch plunger.
5. Secure the switch jam nuts.
6. Test the adjustment as follows:
A. Ensure that the parking brake is engaged and you
are not sitting on the seat, then start the engine.
B. Move the control levers out of the neutral locked
position.
The engine should stop. If not, recheck the
adjustment you made to the switch.
7. Install the front panel.
41
(Figure 42).