Premaintenance Procedures; Lubrication; Greasing The Bearings And Bushings - Toro 30695 Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Premaintenance
Procedures
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
Figure 28
Service Interval Chart

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose, lithium-based grease. If
the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation.
Lubricating bearings and bushings daily when operating
conditions are extremely dusty and dirty. Dusty and dirty
operating conditions could cause dirt to get into the bearings
and bushings, resulting in accelerated wear. Lubricate the
grease fittings immediately after every washing, regardless of
interval specified.
1. Wipe the grease fittings clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the fittings.
3. Wipe off excess grease.
Figure 29 and
fittings.
Important: The fittings on the axles of the caster wheels
are not illustrated. Ensure that you grease these fittings
as well.
31
Figure 30 illustrate the locations of the grease