Setup; Assembling The Tiller - Toro 58602 Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Assembling the Tiller

Parts needed for this procedure:
2 Wheel
1 Tine shield
4 Bolt (M8 x 20 mm)
2 Hairpin cotter
1 Lock pin
4 Washer (M8)
2 Bolt (M8 x 45 mm)
6 Locknut (M8)
2
Washer (12 mm)
4 Bolt (M6 x 16 mm)
4 Locknut (M6)
1 Drag stake handle assembly
1 Axle
1 Left outer tine
1 Right outer tine
Description
Wheel
Tine shield
Bolt (M8 x 20 mm)
Hairpin cotter
Lock pin
Washer (M8)
Bolt (M8 x 45 mm)
Locknut (M8)
Washer (12 mm)
Bolt (M6 x 16 mm)
Locknut (M6)
Drag stake handle assembly
Axle
Left outer tine
Right outer tine
Engine oil
Qty.
2
1
4
2
1
4
2
6 Assemble the tiller.
2
4
4
1
1
1
1
1 Add oil to the engine.
Procedure
1. Install the axle and wheels to the lower tail
mount.
1. Axle
2. Lower tail mount
3. Wheel (2)
6
Use
Figure 3
4. Washer-12 mm (2)
5. Hairpin cotter (2)
g356258