Table of Contents
Advertisement
Cutting Unit Specifications
Center cutting unit
Wing cutting units
Height of cut
Construction
Cutter drive
Blades
Suspension and castor
wheels
Anti-scalp features
Cutting unit covers
Note: Specifications subject to change without notice.
Measurements
Width of cut
overall
center cutting unit
wing cutting unit
center and one wing
cutting unit
Overall width
cutting units down
cutting units up (transport)
Overall length
3 blades. Cutting unit can be tipped and latched for maintenance.
2 blades.
1–5 in. (25–177 mm) adjustable in 1/2 in. (13 mm) increments. Center cutting unit ad-
justment is achieved by changing spacers on castor wheels and length of support
chains. Wing cutting unit adjustment is achieved by adding or removing an equal num-
ber of spacers from the castor fork, positioning the castor wheel axles in the high or low
height-of-cut holes in the castor forks and securing the pivot arms to the selected
height-of-cut bracket holes.
Housing is made of 12 gauge steel and reinforced with channels and plates.
One hydraulic motor per cutting unit. Each motor powers one spindle directly while
remaining spindles are driven by a B section v-belt. Spindle shafts are supported by
two externally sealed, greaseable, tapered roller bearings. All blades, spindles and
belts are interchangeable.
Seven 19 in. long, 1/4 in. thick, heat-treated steel.
Center cutting unit has two front castors, consisting of 8 in. pneumatic wheel and
tire assembly with sealed ball bearings. Rear of cutting unit is suspended from lift
arms with adjustment for cutting unit pitch. Hydraulic counter balance and lift
system designed integral with cutting unit for maximum flotation and traction. Wing
cutting units have one front castor and one rear castor consisting of 8 in. pneumatic
wheel and tire assembly with sealed ball bearings. Hydraulic counter balance and
lift system designed integral with cutting unit for maximum flotation and traction.
Anti-scalp cup located on each blade. Anti-scalp rollers. Adjustable skid on each
end of cutting unit.
Steel and plastic covers.
124 in. (315 cm)
54 in. (137 cm)
37 in. (94 cm)
89 in. (226 cm)
127 in. (322 cm)
71 in. (180 cm)
144 in. (366 cm)
13
Height
Height with ROPS
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
Weight (with cutting units and
fluids)
58 in. (147 cm)
81 in. (206 cm)
6 in. (15 cm)
45 in. (114 cm)
42 in. (106 cm)
55-1/2 in. (141 cm)
3905 lb. (1757 kg)
Advertisement
Table of Contents
