Electrical Line Safety - Toro 25450W Operator's Manual

Maintenance and Storage
•
Lower the attachment(s), stop the engine, wait for all
moving parts to stop, and remove the key whenever you
adjust, clean, or repair the machine.
•
Do not touch parts that may be hot from operation.
Allow them to cool before attempting to maintain, adjust,
or service the machine.
•
Clean debris from all attachments, drives, mufflers, and
the engine to help prevent fires. Clean up oil and fuel
spills.
•
Let the engine cool before storing the machine, and do
not store it near an open flame.
•
Park the machine on level ground.
•
Do not allow untrained personnel to service the machine.
•
Use jack stands to support components when required.
•
Carefully release pressure from components with stored
energy.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Keep nuts and bolts tight. Keep all equipment in good
condition.
•
Do not tamper with safety devices.
•
Use extra care when handling fuels. They are flammable
and vapors are explosive.
– Use only an approved container.
– Do not remove the fuel cap or add fuel when the
engine is running. Allow the engine to cool before
refueling. Do not smoke.
– Do not refuel the machine indoors.
– Do not drain the fuel indoors.
– Do not store the machine or a fuel container inside
where there is an open flame, such as near a water
heater or furnace.
– Do not fill a container while it is inside a vehicle,
trunk, pickup bed, or any surface other than the
ground.
– Keep the container nozzle in contact with the tank
during filling.
•
Use only genuine Toro replacement parts.
•
Disconnect the battery before making any repairs.
Disconnect from the negative battery terminal first and
from the positive battery terminal last. Connect to the
positive terminal first and to the negative terminal last.
•
Charge the battery in an open, well-ventilated area,
away from spark and flames. Unplug the charger before
connecting or disconnecting it from the battery. Wear
protective clothing and use insulated tools.
•
Battery acid is poisonous and can cause burns. Avoid
contact with skin, eyes, and clothing. Protect your face,
eyes, and clothing when working with a battery.
•
Battery gases can explode. Keep cigarettes, sparks, and
flames away from the battery.
•
Keep your body and hands away from pinhole leaks
or nozzles that eject high-pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks; never use
your hands. Hydraulic fluid escaping under pressure can
penetrate skin and cause injury, requiring surgery within
a few hours by a qualified surgeon; otherwise, gangrene
may result.
•
Allow the machine to cool before storing it.

Electrical Line Safety

WARNING
If you leave the seat of the machine or touch
any part of the machine when it is charged with
electricity, serious injury or death could result.
Do not leave the seat of the machine if the machine
is charged with electricity.
Important: In the event the machine becomes
electrically charged, immediately contact the proper
emergency and utility authorities to secure the area.
If you are operating the machine and it becomes
electrically charged, do not leave the seat until the source
of electrical energy is removed from the machine. Keep
other people away from the machine if it is electrically
charged.
Note: It is possible to strike a utility line without the machine
becoming charged.
•
It is likely (but not always the case) that the power-source
interrupter or breaker will trip, but to ensure your safety,
always assume that the machine may be conducting
electricity.
Note: You will be safe as long as you do not leave the
seat of the machine.
•
Touching any part of an electrically charged machine while
you are on the ground may cause a severe electric shock.
Note: Do not allow another individual to touch or
approach the machine when it is charged.
6