Specifications; Attachments/Accessories; Operation; Preparing For Work - Toro 25450W Operator's Manual

Figure 18
1. Battery On position
•
Rotate the battery disconnect clockwise to the On
position.
•
Rotate the battery disconnect counterclockwise to the
Off position.

Specifications

Note: Specifications and design are subject to change
without notice.
Machine Dimensions and Weight Data
Wheel base
Overall height (to the top of
the ROPS)
Overall width (at the tires)
Minimum ground clearance
Turning radius (2-wheel
steering)
Turning radius (4-wheel
steering)
Weight (without attachments)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
2. Battery Off position
195 cm (76.8 inches)
281 cm (110 inches)
218 cm (85.8 inches)
28.5 cm (11.2 inches)
115 cm ( 291 inches)
391 cm (154 inches)
4,570 kg (10,075 lb)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Preparing for Work

Before operating the machine on the job site, review the
following items:
•
Gather all relevant information available about the job
site before you begin working.
•
Review all blueprints and other plans, and identify all
existing or proposed structures, characteristics of the
landscape, and other proposed jobs in the area scheduled
at the same time as your job.
Note the following items at the job site:
– Changes in elevation in the proposed work area
– The condition and type of soil in the proposed work
area
– Locations of structures, water, railroad tracks, and
other obstructions that you will need to work near
or around
– Utility markers, meters, and poles
– If the work site is near or on a roadway with traffic,
call the local authorities regarding proper safety
procedures and regulations.
– Access to the site
•
Call your local One-Call service (811 in the US) or the
One-Call referral number (888-258-0808 in the US and
Canada) and ask the participating utility companies to
locate and mark their underground utility lines. Also call
utility providers that are not part of the One-Call system.

Adding Fuel to the Engine

Fuel tank capacity: 182 L (48 US gal)
Fuel type: ultra-low sulfur diesel (ULSD)
Note: Using other fuels can cause a loss of engine power
and high fuel consumption.
Important: Do not use kerosene or gasoline instead of
diesel fuel; otherwise, you will damage the engine.
Use only diesel fuel for the machine that meets Specification
D975 of the American Society for Testing and Materials
International. See your diesel fuel distributor.
Use only clean, fresh diesel fuel or biodiesel fuels with low
(<500 ppm) or ultra low (<15 ppm) sulfur content. The
minimum cetane rating should be 40. Purchase only enough
fuel that you expect to use within 30 days to ensure that it
stays fresh.
Use summer-grade diesel fuel (No. 2-D) at temperatures
above 20°F (-7°C) and winter-grade diesel fuel (No. 1-D or
No. 1-D/2-D blend) below 20°F (-7°C). Using winter-grade
22