Toro 25450W Operator's Manual page 21

Seat-Height and Seat-Slide Buttons
1. Seat-slide buttons
2. Seat-height buttons
3. Seat-slide lever
4. Seat-rotation lever
•
Seat-height buttons–use them to adjust the seat pad up
or down (Figure 17).
•
Seat-slide buttons—use them to slide the seat pad
forward or rearward (Figure
Seat-Frame-Slide Lever and Seat-Base-Slide Lever
•
Seat-frame-slide lever—Use this lever to adjust the
entire seat and frame forward or rearward
•
Seat-base-slide lever—Use this lever to move the seat
base forward or rearward on the seat frame
Seat-Rotation Lever and Seat-Weight Compensator
•
Seat-rotation lever—Use this lever to unlock the seat
so that you can rotate the seat to the desired position.
The seat will rotate 360° and lock into position at 10°
increments (Figure 17).
Note: Rotate the seat to the Front position before
driving the machine.
•
Seat-weight compensator—Rotate this lever for the
weight compensator to adjust the seat support tension for
the weight of the operator
– Rotate the lever for the weight compensator clockwise
to increase the support tension of the seat.
Figure 17
5. Seat-frame slide bar
6. Weight compensator
7. Armrest-height control
8. Lumbar knob (located on
the seat back)
17).
(Figure
(Figure
(Figure 17).
– Rotate the lever for the weight compensator
counterclockwise to reduce the support tension of
the seat.
Armrest-Height Control
Rotate the armrest-height control to raise or lower the
armrest (Figure
Seat-Lumbar Knob
Rotate the seat-lumbar knob, found behind the seat, to adjust
the back lumbar support for best comfort
Seat Belt
WARNING
Operating the machine without the rollover
protection system (ROPS) securely in place can
result in serious injury or death if the machine rolls
over.
• Ensure that the roll bar is securely in place.
• Always wear a seat belt with the ROPS in place.
• Ensure that the operator seat is properly secured
to the machine.
Note: Regulations in some localities require that seat belts on
construction machines be 76 mm (3 inch) wide. Check with
local authorities regarding the requirements for seat belts.
•
To fasten the seat belt, insert the tab end into the left
buckle.
Note: Ensure that the tab end and the buckle are
securely fastened.
•
To release the seat belt, push the button on the buckle.
17).
Battery-Disconnect Switch
The battery-disconnect switch is located behind the right
17).
engine cowl (Figure
battery from the machine.
21
17).
18); use it to electrically disconnect the
(Figure 17).