Installing The Wheels; Installing The Steering Wheel - Toro 07264 Operator's Manual

Step
1

Installing the Wheels

Parts needed for this step:
4 Wheel assembly
Procedure
Note: This procedure is only needed for Model
No. 07264TC.
1. Remove the fasteners securing the wheels.
2. Remove the shipping bracket secured to the
wheel studs.
3. Mount the wheels with the previously removed
fasteners (Figure 3) and torque to 45-65 ft-lb
(61-88 N⋅m).
Figure 3
1. Wheel assembly
2. Wheel nut
3. Wheel stud (rear wheel hub
shown)
Step
2
Installing the Steering
Wheel
Parts needed for this step:
1 Steering wheel
Procedure
Note: This procedure is only needed for Model
No. 07264TC.
1. Remove the nut and washer from the steering
shaft.
2. Slide the steering wheel and washer onto the
shaft. Position the steering wheel on the shaft
so that the cross beam is horizontal when the
tires are pointed straight ahead and the thicker
spoke of the steering wheel is downward.
3. Secure the steering wheel to the shaft with the
nut (Figure 4). Torque the nut to 18-22 ft-lb
(24-29 N⋅m)
Figure 4
1. Steering wheel
2. Nut
12
3. Washer
4. Foam seal