Installing The Cargo Box - Toro 07264 Operator's Manual

Figure 7
1. Hitch
Step
6

Installing the Cargo Box

Parts needed for this step:
1 Cargo box
1
Right-hand pivot bracket
1 Left-hand pivot bracket
4
Flange head screw (3/8 x 1 inch)
1 Bolt (5/16 x 3/4 inch)
1
Flange nut (5/16 inch)
Procedure
Note: This procedure is only needed for Model
No. 07264TC.
1. Position the cargo box onto the frame. The
cargo box must lay flat and be centered.
2. Mount the left hand pivot bracket to the left
rear corner of the frame with 2 flange head
screws (3/8 x 1 inch). Position the bracket as
shown in Figure 8.
Figure 8
1. Pivot bracket
3. Slide the cargo box mounting hole onto the
pivot bracket (Figure 9).
Figure 9
1. Cargo box
2. Pivot bracket
4. Insert the right hand pivot bracket into the
mounting hole in the cargo box and then
mount it to the frame.
5. Have another person help to raise the cargo
box.
6. Loosen the bolt securing the prop rod clip to
the frame until you can slide the J-hook end of
the prop rod under the clip (Figure 10).
14
3. Cargo box mounting hole