Servicing The Engine Oil - Toro 07264 Operator's Manual

Table of Contents

Advertisement

1. Blow compressed air from the inside to the
outside of the dry filter element. Keep the
air hose nozzle at least 2 inches (51 mm)
from the filter and move the nozzle up and
down while rotating the filter element.
Important: To prevent damage to
the filter element, do not exceed 100 psi
(689 kPa) air pressure.
2. Inspect the filter element for holes and
tears by looking through the filter toward a
bright light.
Installing the Filter Element
Important: To prevent engine damage,
always operate the engine with the complete
air cleaner assembly installed.
1. Inspect the new filter for shipping damage.
Check the sealing end of the filter.
Important: Do not install a damaged
filter.
2. Insert the new filter into air cleaner body.
Ensure the filter is sealed properly by applying
pressure to the outer rim of the filter when
installing it. Do not press on the flexible center
of the filter.
3. Install the cover and secure the latches.

Servicing the Engine Oil

Check the oil level before each use.
Change the oil after the first 25 operating
hours and every 100 operating hours thereafter.
Change the oil twice as often in special operating
conditions; refer to Maintaining the Vehicle under
Special Operating Conditions.
Note: Change the oil more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ,
or higher)
Viscosity: See the table below.
Figure 34
Checking the Oil Level
To check the oil level, refer to Checking the Engine
Oil in Operation, page 22.
Changing the Oil
1. Start the vehicle and let it run for a few minutes
to warm the oil.
2. Park the machine on a level surface, set the
parking brake, turn the ignition off, and
remove the key.
3. Raise the bed and secure it with the prop rod.
4. Disconnect the spark plug wires and battery
cables.
5. Remove the drain plug (Figure 35) and let the
oil flow into a drain pan. When the oil has
drained completely, install the drain plug and
torque it to 13 ft-lb (17.6 N⋅m).
32

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07264tcWorkman 1110

Table of Contents