Changing Oil And Filter; Fuel System; Fuel Lines And Connections; Replacing The Fuel Filter - Toro 07253TC Operator's Manual

Changing Oil and Filter

1. Park the machine on a level surface and turn the
engine off.
2. Raise bed and secure it with the prop rod.
3. Remove the drain plug (Fig. 23) and let oil flow
into the drain pan. When the oil stops, install the
drain plug.
Note: Dispose of the used oil at a certified
recycling center.
Figure 23
1. Engine oil drain plug
2. Engine oil filter
4. Remove the oil filter (Fig. 23). Apply a light
coat of clean oil to the new filter gasket.
5. Screw the filter on until gasket contacts the
mounting plate, then tighten the filter an
additional 1/2 to 3/4 turn further. Do not
overtighten.
6. Pour oil into fill opening until the oil level is up
to the "FULL" mark on the dipstick. Add the oil
slowly and check the level often during this
process. Do not overfill.
7. Install the dipstick firmly in place.
Maintenance

Fuel System

Fuel Lines and Connections

Check lines and connections every 400 hours or
yearly, whichever occurs first. Inspect for
deterioration, damage, or loose connections.

Replacing the Fuel Filter

Replace the fuel filter after every 800 operating hours
or yearly, whichever occurs first.
1. Raise the bed and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the
fuel lines.
1. Fuel filter
4. Install the new fuel filter to the fuel lines with
the clamps previously removed. The filter to be
mounted so arrow points toward the carburetor.
Removing Debris From The
Engine
Every 100 hours of operation (more often under
extremely dusty, dirty conditions) clean the rotating
screen and external surfaces as necessary.
IMPORTANT: Operating the engine with a
blocked rotating screen, dirty or plugged cooling
– 29 –
1
Figure 24