Vibration Level - Toro 07253TC Operator's Manual

26. Before disconnecting or performing any work on
the hydraulic system, all pressure in system must
be relieved by stopping engine, cycling dump
valve from raise to lower and/or lowering box
and attachments. Place the remote hydraulics
lever in the float position. If box must be in
raised position, secure with safety support.
27. To make sure entire machine is in good condition,
keep all nuts, bolts and screws properly tightened.
28. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves and
accumulation of dirt.
29. If the engine must be running to perform a
maintenance adjustment, keep hands, feet,
clothing, and any parts of the body away from the
engine and any moving parts. Keep everyone
away.
30. Do not overspeed engine by changing governor
settings. Maximum engine speed is 3650 rpm. To
assure safety and accuracy, have an Authorized
TORO Distributor check maximum engine speed
with a tachometer.
31. If major repairs are ever needed or assistance is
required, contact an Authorized TORO
Distributor.
32. To be sure of optimum performance and safety,
always purchase genuine
TORO replacement parts and accessories.
Replacement parts and accessories made by other
manufacturers could be dangerous. Altering this
vehicle in any manner may affect the vehicle's
operation, performance, durability or its use may
result in injury or death. Such use could void the
product warranty of The TORO Company.
33. This vehicle should not be modified without the
TORO Company's authorization. Direct any
inquiries to:
The TORO Company
Commercial Division
Safety
Vehicle Engineering Department
300 West 82nd St.
Bloomington, Minnesota 55420 USA
Sound Pressure Level
This unit has an equivalent continuous A-weighted
sound pressure at the operator ear of: 80 dB(A) based
on measurements of identical machines per J1174-
MAR 85 procedures.

Vibration Level

This unit does not exceed a vibration level of 2.5 m/s
at the hands based on measurements of identical
machines per ISO 5349 procedures.
This unit does not exceed a vibration level of 2.5 m/s
at the posterior based on measurements of identical
machines per ISO 2631 procedures.
– 7 –
2
2