Cleaning The Filter Element; Installing The Filter Element; Engine Oil; Service Interval/Specification - Toro 07253TC Operator's Manual

4. Gently slide the filter out of the air cleaner body
to reduce the amount of dust dislodged (Fig. 22).
Avoid knocking the filter against the air cleaner
body.
5. Inspect the filter and discard if damaged.

Cleaning the Filter Element

IMPORTANT: Do not wash or reuse a damaged
filter.
1. Washing method:
A. Prepare a solution of filter cleaner and
water and soak the filter element about 15
minutes. Refer to directions of the filter
cleaner carton for complete information.
B. After soaking the filter for 15 minutes, rinse
it with clear water. Rinse the filter from
clean side to dirty side.
IMPORTANT: To prevent damage to the
filter element, maximum water pressure
must not exceed 276 kPa (40 psi).
C. Dry the filter element using warm, flowing
air (71°C, 160°F max.), or allow element to
air dry.
IMPORTANT: Do not use a light bulb to
dry the filter element because damage
could result.
2. Compressed air method:
A. Blow compressed air from inside to the
outside of dry filter element. Keep the air
hose nozzle at least 5cm (2 inches) from the
filter and move the nozzle up and down
while rotating the filter element.
IMPORTANT: To prevent damage to the
filter element, do not exceed 689 kPa (100
psi) air pressure.
B. Inspect for holes and tears by looking
through the filter toward a bright light.
Maintenance

Installing the Filter Element

IMPORTANT: To prevent engine damage, always
operate the engine with the complete air cleaner
assembly installed.
1. Inspect new filter for shipping damage. Check
the sealing end of the filter.
IMPORTANT: Do not install a damaged filter.
2. Insert the new filter properly into the air cleaner
body. Ensure the filter is sealed properly by
applying pressure to outer rim of the filter when
installing. Do not press on the flexible center of
the filter.
3. Reinstall the cover and secure the latches.

Engine Oil

Service Interval/Specification

Check the oil level before each use.
Change oil:
• After the first 8 operating hours.
• After every 50 operating hours.
Replace the oil filter every 100 hours.
Note: Change oil and oil filter more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SE, SF, or SG)
Crankcase Capacity: 1.6 liters (48 oz./1-1/2 qt.)
when the filter is changed
Viscosity: See table below
– 28 –