Cab Controls - Toro 31598 Operator's Manual

Cruise-Control Switch
The cruise-control switch sets your desired speed of the
machine.
Press the switch forward to engage the cruise control and
rearward to disengage it (Figure
Audible Alarm (Console)
The alarm is activated when a fault is detected.
The buzzer sounds when the following occur:
•
When the engine sends a stop fault
•
When the engine sends a check-engine fault
•
When the fuel level is low

Cab Controls

1. Air-conditioning switch
2. Air-recirculation control
3. Fan control
Air-Recirculation Control
This control either recirculates the air in the cabin or draws
outside air into the cabin
•
Set it to recirculate the air when using air conditioning.
•
Set it to draw air in when using the heater or fan.
Fan Control
Rotate the fan-control knob to regulate the speed of the fan
(Figure 11).
Temperature Control
Rotate the temperature-control knob to regulate the air
temperature in the cab (Figure
10).
Figure 11
4. Temperature control
5. Windshield-wiper switch
6. Blank switches for optional
kits
(Figure 11).
11).
Windshield-Wiper Switch
Use the windshield-wiper switch to turn the windshield
wipers to the O or O
N
Lights Switch
Use the lights switch to turn the headlights and tail-lights to
the O or O position
N FF
Flashers Switch
Use the flashers switch to turn the flashers (hazard lights) to
the O or O position
N FF
Air-Conditioning Switch
Use the air-conditioning switch to turn the air conditioning
on or off (Figure 11).
Windshield Latch
Lift up the latch to open the windshield
the latch to lock the windshield in the open position. Pull out
and down on the latch to close and secure the windshield.
1. Windshield latch
Rear-Window Latch
Lift up the latch to open the rear window. Press in the latch
to lock the window in the open position. Pull out and down
on the latch to close and secure the window
Important: You must close the rear window before
opening the hood; otherwise, you may damage the
window.
Power Point
The power point, located next to the console on the side
of the power center, is used to power optional electrical
accessories (Figure 10).
Seat-Adjusting Lever
Pull out the lever to slide the seat forward or rearward.
18
position (Figure 11).
FF
(Figure 10).
(Figure 10).
(Figure 12). Press in
Figure 12
(Figure 12).