Service Interval Chart; Premaintenance Procedures; Pre-Maintenance Safety - Toro 31598 Operator's Manual

Maintenance Service
Interval
Every 2,000 hours
Every 2 years
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Service Interval Chart

Premaintenance
Procedures

Pre-Maintenance Safety

•
Keep all parts of the machine in good working condition
and all hardware tightened, especially blade-attachment
hardware. Replace all worn or damaged decals.
•
Never allow untrained personnel to service the machine.
•
Before adjusting, cleaning, or repairing the machine, do
the following:
1. Move the machine to level ground.
2. Disengage the drives.
3. Lower the cutting units.
4. Move the traction pedal to the N
5. Engage the parking brake.
Maintenance Procedure
• Adjust the valve clearance.
• Flush the cooling system and replace fluid.
• Replace moving hoses.
Figure 42
position.
EUTRAL
6. Move the throttle switch to the
7. Shut off the engine and remove the key.
8. Wait for all moving parts to stop.
•
Whenever you park or store the machine, or leave it
unattended, lower the cutting units unless you use a
positive mechanical lock.
•
If possible, do not perform maintenance on the machine
while the engine is running. If you must run the engine to
perform maintenance on the machine, keep your hands,
feet, other body parts, and clothing away from all moving
parts, the mower-discharge area, and the underside of
the mowers.
•
Do not touch parts of the machine or an attachment
that may be hot from operation. Allow the parts to cool
before attempting to maintain, adjust, or service them.
•
Use jack stands to support the machine and/or its
components when required.
37
- position.
LOW IDLE