Toro 31598 Operator's Manual page 54

Figure 82
1. Hydraulic motor
6. Lift the motor off the mower deck and lay it on top
of the mower deck.
7. Remove the old belt from around the spindle pulleys
and idler pulley.
8. Route the new belt around the spindle pulleys and
idler-pulley assembly
Figure 83
9. Adjust the stop screw on the idler pulley and tighten
the jam nuts.
Replacing the Side Mower-Deck Belts
Note: To remove the lower belt, you must remove the upper
belt first.
1. Lower the mower deck to the floor.
2. Remove the belt covers from the top of the mower
deck and set the covers aside.
3. Remove the bolts securing the hydraulic motor to the
mower deck (Figure
4. Lift the motor off the mower deck and lay it on top
of the mower deck.
5. Using a ratchet wrench or similar tool, move the idler
pulleys away from the drive belt to release the belt
tension and allow the belt to slip off the pulleys
84).
2. Mounting bolts
(Figure 83).
114-0922
82).
1. Idler pulleys
6. Remove the old belt from around the spindle pulleys
and idler pulley.
7. Route the new belt around the spindle pulleys and
idler-pulley assembly
(Figure
54
Figure 84
(Figure 85 and Figure 86).
Figure 85
Right deck
Figure 86
Left deck