Installing The Steering Wheel; Installing The Cutting Units - Toro 04356 Operator's Manual

2. Connect the positive battery cable (red) from the starter
solenoid to the positive post (+) of the battery (Fig. 7).
Secure it with a wrench and coat the terminal with
petroleum jelly. Make sure the cable will clear the seat,
in the rear-most position, which could cause wear or
damage to the cable.
Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1
Figure 7
1. Negative (–)
3. Connect the black ground cable to the negative (–) post
of the battery. Secure it with a wrench and coat the
terminal with petroleum jelly.
4. Place the terminal covers over the battery posts.
5. Install the battery clamp and cover and secure them
with the wing nuts.

Installing the Steering Wheel

1. Slide the steering wheel onto the steering shaft and
secure it with the jam nut (Fig. 8). Torque it to 32 ft.-lb.
(43 N⋅m).
2. Install the cap to the steering wheel with the screw
(Fig. 8).
Note: The steering wheel may be adjusted fore and aft for
operator comfort by loosening the three mounting screws,
pivoting the steering wheel to the desired operating
position, and tightening the screws (Fig. 8).
2
2. Positive (+)
14
1
4
Figure 8
1. Steering wheel
2. Jam nut

Installing the Cutting Units

For Cutting Unit Models 04610 and 04611
Note: When sharpening, setting the height-of-cut or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
on the front of the frame to prevent damage to the hoses.
1. Remove the cutting units from the cartons. Assemble
and adjust them as listed in the cutting unit Operator's
Manual. Use the gauge bar from the loose parts kit to
adjust the height of cut.
2. Mount a washer and ball stud to each end of the front
roller on the cutting units (Fig. 9).
1
2
Figure 9
1. Pull frame
2. Pull arm
2
3
3. Cap
4. Mounting screws
3
3. Ball stud