Lubrication - Toro 03200 Reelmaster 3100-D Operator's Manual

Lubrication

The traction unit has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If machine is operated under normal conditions, lubricate
bearings and bushings after every 50 hours of operation.
Bearings and bushings must be lubricated daily when
operating conditions are extremely dusty and dirty. Dusty
and dirty operating conditions could cause dirt to get into
the bearings and bushings, resulting in accelerated wear.
Lubricate bearings and bushings immediately after every
washing, regardless of the interval listed.
The traction unit bearings and bushings that must be
lubricated are: Rear cutting unit pivot (Fig. 43), Front
cutting unit pivot (Fig. 44), SideWinder cylinder ends (2)
(Model 03201 only) (Fig. 45), Steering pivot (Fig. 46),
Rear lift arm pivot and lift cylinder (2) (Fig. 47), Left front
lift arm pivot and lift cylinder (2) (Fig. 48), Right front lift
arm pivot and lift cylinder (2) (Fig. 49), Neutral adjust
mechanism (Fig. 50), Mow/Transport slide (Fig. 51), Belt
tension pivot (Fig. 52) Steering cylinder (Fig. 53).
Note: If desired, an additional grease fitting may be
installed in other end of steering cylinder. Tire must be
removed, fitting installed, greased, fitting removed and
plug installed (Fig. 54).
Important Do not lubricate Sidewinder (model 03201)
cross tube, bearing blocks are self lubricated.
Figure 43
33
Figure 44
(2)
Figure 45
Figure 46