Check Tire Pressure - Toro 03200 Reelmaster 3100-D Operator's Manual

Group 2 Hydraulic Fluid (Hot Climate– Heavy Duty)
Note: The fluids within this group are interchangeable.
ISO VG 68 anti-wear hydraulic fluid
Mobil
Amoco
Castrol
Chevron
Conoco
Exxon
Gulf
Kendall
Marathon
Pennzbell
Phillips
Shell
76 Lubricants
Sunoco
Texaco
Important Group 1 fluids are recommended for use at
typical ambient temperatures of 32 F (0 C) to 105 F
(41 C). The ISO Type 46/68 fluid has been found to offer
optimal performance in a wide range of temperature
conditions for the average user. The Universal Tractor
Fluids offer similar performance for those who prefer them,
with perhaps some slight loss of efficiency at high ambient
temperatures compared to the Type 46/68 fluids.
Group 2 fluids are recommended for heavy-duty use in hot
climates where ambient temperatures range from about
70 F (20 C) to 120 F (49 C). Use at lower ambient
temperatures may result in hard starting, increased engine
laboring while cold, sluggish or non-operating spool valves
while cold and high filter back-pressure due to the higher
viscosity of these fluids.
Note: When changing from one type of hydraulic fluid to
another, be certain to remove all the old fluid from the
system, as some fluids are incompatible with others.
Group 3 Hydraulic Fluid (Biodegradable)
ISO VG 32/46 anti-wear hydraulic fluid
Mobil
Note: This biodegradable hydraulic fluid is not compatible
with the fluids in Group 1 and 2.
Note: When changing from standard fluid to the
biodegradable type, be certain to follow approved flushing
procedures as published by Mobil. Contact your local Toro
Distributor for details.
Important Use only types of hydraulic fluids
specified. Other fluids could cause system damage.
DTE 26
Rykon AW No. 68
AWS 68
Hydraulic Oil AW ISO 68
Hydroclear AW 68
Nuto H 68
Harmony 68AW
Four Seasons AW 68
ISO 68
AW Hydraulic Oil 68
Magnus A ISO 68
Tellus 68
AW 68
SunVis 868
Rando HD 68
EAL 224H
23
Note: A red dye additive for the hydraulic system fluid is
available in 2/3 oz. bottles. One bottle is sufficient for 4–6
gal. of hydraulic fluid. Order Part No. 44–2500 from your
Authorized Toro Distributor.
1
Figure 34
1. Hydraulic tank cap
1. Position machine on a level surface, lower the cutting
units and stop the engine.
2. Clean area around filler neck and cap of hydraulic tank.
Remove cap from filler neck.
3. Remove dipstick from filler neck and wipe it with a
clean rag. Insert dipstick into filler neck; then remove it
and check level of fluid. Fluid level should be within
1/4 inch of mark on dipstick.
4. If level is low, add appropriate fluid to raise level to full
mark.
5. Install dipstick and cap onto filler neck.

Check Tire Pressure

The tires are over–inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure
in tires is 14 –18 psi.
Important
Maintain recommended pressure in all tires
to assure a good quality–of–cut and proper machine
performance.
Danger
Low tire pressure decreases the machine's sidehill
stability. Do not under inflate tires. This could
cause a rollover, which may result in personal
injury or death.