Hour Meter; Oil Pressure Warning Light; Parking Brake - Toro 03200 Reelmaster 3100-D Operator's Manual

Cutting Unit Shift Lever
To lower cutting units to the ground, move lift lever
forward. Cutting units will not drop unless engine is
running and will not operate in raised position. To raise
cutting units, pull lift lever rearward to the RAISE position.
Model 03201 only– Move lever to the right or left to move
cutting units in same direction. This should only be done
when cutting units are raised or if they're on the ground
and the machine is moving.
Danger
The machine is most stable on a side hill when the
cutting units are shifted uphill. Shifting cutting
units downhill decreases machine stability. This
could cause a rollover, which may result in
personal injury or death.
Note: Lever does not have to be held in forward position
while cutting units are lowered.
Cutting Unit Drive Switch
The switch has two positions: ENGAGE and
DlSENGAGE. Rocker switch operates a solenoid valve, on
valve bank, to drive cutting units.
7
8
10
11
Figure 37
1. Throttle

2. Hour meter

3. Temperature light
4. Oil pressure light
5. Glow plug indicator
6. Alternator light
2
3
4
1
5
6
9
7. Cutting unit drive switch
8. Cutting unit shift lever
9. Ignition switch

10. Parking brake

11. Lift lever lock
Hour Meter
Indicates the total hours of machine operation. The Hour
Meter starts to function whenever the key switch is ON.
Engine Coolant Temperature Warning
Light
Light glows if engine coolant temperature is high. If
traction unit is not stopped and coolant temperature rises
another 10 F., the engine will kill.

Oil Pressure Warning Light

Light glows if engine oil pressure drops below a safe level.
Alternator Light
The amp light should be off when engine is running. If it is
on, the charging system should be checked and repaired as
necessary.
Glow Plug Indicator
Indicator light will glow when glow plugs are operating.
Parking Brake
Whenever the engine is shut off, the parking brake must be
engaged to prevent accidental movement of the machine.
To engage the parking brake, pull up on lever. Engine will
stop if traction pedal is depressed with parking brake
engaged.
Lift Lever Lock
Move lever rearward to prevent cutting units from
dropping.
Reel Speed Control
(Located under console cover) – To obtain the desired clip
rate (reel speed), rotate reel speed control knob to
appropriate setting for height–of–cut setting and mower
speed. Refer to Selecting Clip Rate section of Manual.
Backlap Control
(Located under console cover) – Rotate knob clockwise for
backlapping and counterclockwise for mowing. Do not
change knob position when reels are rotating.
25