Connect Battery; Check Tire Pressure; Install Rear Weight - Toro Groundsmaster 228–D Operator's Manual

Figure 11
1. ROPS
Note: When operating machine, always use the seat belt
and ROPS together.

Connect Battery

1. Lift engine cover. Check to see that the battery is
securely fastened in place (Fig. 12).
Figure 12
1. Positive (+) battery cable
2. Check battery charge with a hydrometer. If battery
needs charging, be sure at least one of the battery cables
is disconnected from the battery before the charger is
connected.
2. Negative (–) battery
cable
18
3. Secure the cables to the proper battery post. The
positive (+) red cable goes to the positive post and the
negative (–) black cable goes to the negative post on the
battery.
Warning
Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
Note: Make sure battery cables are routed away from any
sharp edges or moving parts.
4. Coat the terminal with sealant such as Grafo 112X, Toro
Part No. 505-47 and install the rubber boot onto
positive terminal.

Check Tire Pressure

The tires are over–inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure
in front and rear tires is 20 psi.

Install Rear Weight

Four Wheel Drive Groundsmaster 228–D Series Traction
Units do not need additional rear weight to comply with
ANSI B71.4–1999 Standard.