Maintenance; Recommended Maintenance Schedule(S); Premaintenance Procedures; Disengaging The Hydrostatic Drive - Toro 23510 Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Premaintenance
Procedures
Disengaging the Hydrostatic
Drive
If you need to push the machine unpowered, you must
release the hydrostatic drive. To release the drive, pull the
hydrostatic-drive bypass lever
locking it in the out position. The front wheels will now
rotate.
To engage the drive, pull up on the bypass lever until it snaps
back into the machine.
Maintenance Procedure
• Change the engine oil.
• Check the engine oil level.
• Check the seed gate.
• Inspect the air-cleaner elements.
• Check the tire pressure.
• Check the blades for wear or damage.
• Clean the engine and exhaust area.
• Clean the debris buildup from under the machine.
• Check for loose fasteners.
• Grease the slicer-shaft bearings.
• Check the condition of the belts.
• Clean the air-cleaner elements. Clean them more frequently in dusty operating
conditions.
• Change the engine oil.
• Check the spark arrester (if equipped).
• Clean under the belt cover.
• Inspect and adjust the spark plug; replace it if necessary.
• Change the hydraulic-transmission fluid.
• Replace the paper air-cleaner element. Replace it more frequently in dusty
operating conditions.
• Replace the spark plug.
• Touch up chipped paint.
(Figure 16) out and down,
G017940
(Rear of machine shown)
1. Hydrostatic-drive bypass lever
18
1
Figure 16