Cleaning Under The Belt Cover; Cleaning The Seed Gate - Toro 23510 Operator's Manual

Cleaning under the Belt Cover

Service Interval: Every 50 hours
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Remove and retain the 4 bolts, lock washers, and 2
spacers securing the belt cover to the left side of the
machine.
4. Remove the cover, and brush out all the debris around
the belt area.
5. Install the belt cover, and tighten all the hardware.
6. Connect the wire to the spark plug.

Cleaning the Seed Gate

1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Drain the fuel from the fuel tank; refer to
the Fuel Tank (page
4. Tilt the machine rearward until the upper handle
rests on the ground, and place a jack stand under the
machine.
Note: If necessary, use 2 people to tilt the machine
rearward.
5. Clean the debris between the frame and the seed gate.
6. Lubricate the sliding surface between the frame and
seed gate with a dry lubricant.
7. Return the machine to the upright position.
8. Fill the fuel tank.
9. Connect the wire to the spark plug.
Emptying
22).
28