Toro 23508—400000000 Tool Turn Manual

Tool Rental Center
PURPOSE
SAFETY
Tool Inspection Process
Perform the necessary maintenance procedures as specified in the following table (for complete procedures, refer to the Operator's Manual):
Maintenance Service Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Revision 1 12-15-2020
Tool Turn Guide
Model No.
Follow the directions below to maintain this tool.
Refer to the product Operator's Manual for complete safety information.
Maintenance Procedure
• Change the engine oil.
• Inspect the air-cleaner elements.
• Check the engine-oil level.
• Check the tire pressure.
• Check the blades for wear or damage.
• Check the seed gate.
• Clean the engine and exhaust area.
• Clean the debris buildup from under the machine.
• Check for loose fasteners.
• Grease the slicer-shaft bearings.
• Check the condition of the belts.
• Clean the air-cleaner elements. Clean them more frequently in dusty operating conditions.
• Change the engine oil.
• Check the spark arrester (if equipped).
• Clean under the belt cover.
• Inspect and adjust the spark plug; replace it if necessary.
• Change the hydraulic-transmission fluid.
• Replace the paper air-cleaner element. Replace it more frequently in dusty operating conditions.
• Replace the spark plug.
• Touch up chipped paint.
20in Turf Seeder
23508—400000000 and Up
Supplier Technical Support #:
800-888-9926 (US and Canada)
Supplier Website: www.Toro.com
Toro Form No 3443-853 Rev A