Characteristics Of System - Robitronic R01502 User Manual

2.1 Characteristics of system

• 3 channels End Point Adjustment.
• Support dual rate function for the STEERING.
• Sub-trim for THROTTLE channel and STEERING channel.
• Model names can use up to 5 letters and numbers, so that easily understood
names can be set. A model memory with different fine setups can be created
by using the model copy function. Sixteen models can be added.
• Brake mixing for large cars (BRAKE)
o Brake mixing of the front and rear wheels of 1/5GP and other large cars
can be adjusted independently.
o Anti-skid braking system (A.B.S) This function applies the brakes so
that the tires of gasoline engine cars, etc. do not lose their grip on the
road even when braking at corners.
• SPEED
o TH-SPEED: Sudden trigger operation on a slippery road surface will
only cause the tires to spin and the model to not accelerate smoothly.
By setting the throttle speed function, operation can be performed
smoothly and easily. It also suppresses battery consumption.
o ST-SPEED: When you sense that the steering servo is too fast, etc.,
the servo operating speed (direction that suppresses the maximum
speed) can be adjusted.
• Auto-Start funktion (ATS)
o A pre-set throttle position, less than full throttle, to be used for the initial
acceleration off the line without having wheel spin. When the trigger is
released, auto-start is turned off and throttle operates normally again.
• TIMER: The TC-3 has two timers: Down_Timer and UP_Timer.
• Digital trim function: The current trim position is displayed on the LCD screen.
7