Canon DP-V2410 Instruction Manual page 44

Item
Internal Sync
Channel Name
Picture Mode
Color Range
The factory default settings for each channel is shown in the following table.
Input Configuration
Select Input Signal
Format
Internal Sync
Channel Name
Picture Mode
Color Range
44 OSD Menu
Synchronizes four inputs for "4K Input".
On: Force synchronization.
Off: Do not force synchronization.
Sets the name of the selected channel. You can input up to 16 alphanumeric characters.
Sets the "Picture Mode".
Sets the quantization range for SDI and HDMI respectively.
Automatic: Sets the range based on signal information automatically.
Full (0-255): Sets to Black level: 0; White level: 1023 (10-bit)/4095 (12-bit).
Limited 1 (16-235): Limits the black and white range.
Black level: 64 (10-bit)/256 (12-bit)
White level: 940 (10-bit)/3760 (12-bit)
Limited 2 (16-255): Limits the black range.
Black level: 64 (10-bit)/256 (12-bit)
White level: 1023 (10-bit)/4095 (12-bit)
Note
• Setting is disabled when "ACESproxy" is selected for "Picture Mode" or "ACESproxy" is
selected for "Color Gamut".
• Operations when "Automatic" is selected are described below.
-
When HDMI is selected, "Full (0-255)" or "Limited 1 (16-235)" is set automatically depending
on HDMI signal information.
-
When "DCI-P3" is selected for "Picture Mode", or "DCI-P3", "Cinema Gamut to DCI" or
"DCI-P3+ to DCI" is selected for "Color Gamut", "Full (0-255)" is set.
-
When "Canon Log" or "Canon Log 2" is selected for "Gamma", "Limited 2 (16-255)" is set.
-
"Limited 1 (16-235)" is set in the other cases.
CH CH1
3G/HD-SDI
Automatic
Automatic
Off
(Blank)
ITU-R BT.709
Automatic
Setting Options (underline indicates factory default)
CH2
HDMI
Automatic
Automatic
Off
(Blank)
ITU-R BT.709
Automatic
CH3 CH4 to CH30
3G-SDI RAW –
Automatic Automatic
Automatic Automatic
Off Off
(Blank) (Blank)
Canon Log ITU-R BT.709
Automatic Automatic
– : not set