Procedures To Attach/Detach Stands - Canon DP-V2410 Instruction Manual

Procedures to attach/detach stands

The stand can be attached in two different positions. This section describes the procedure to attach/detach the stand,
to change the stand position. It also describes the procedure for installing the video display on a rack or a wall.
CAUTION
• Use a flat, clear surface when attaching/detaching the stand.
• The display can tip over if the stand has not been attached.
• Avoid touching the screen during this step as it may damage it.
■ Detaching
1. Place the display with the screen facing down on a soft cloth or cushioning material that is larger than the
display.
2. Remove four fixing screws.
Do not lose the removed screws. Do not use these screws for other purposes.
■ Attaching
1. Place the display with the screen facing down on a soft cloth or cushioning material that is larger than the
display.
2. Align the position of the stand and screw hole on the video display.
Alight the convex part of the stand and concave part of the video display.
3. Fix the left and right stands using two fixing screws respectively.
Rear
Screen side
Outside stand mounting part
Note
• It is recommended to mount both stands in either the outside or inside positions.
12 Installation/Connection
Concave part Stand mounting
screw hole
Inside stand mounting part
Stand
Convex part
Mounting
screw