Canon DP-V2410 Instruction Manual page 37

Item
HDR Range
IDT
ODT
Setting Options (underline indicates factory default)
Setting is enabled when "Canon Log (HDR)", "Canon Log 2 (HDR)", or "SMPTE ST 2084" is selected
for "Gamma".
Canon Log (HDR): Sets the dynamic range to be displayed from 0 to 800% that "Canon Log" has.
100 to 800% (in 100 increments)
Canon Log 2 (HDR): Sets the dynamic range to be displayed from 0 to 1600% that "Canon Log 2"
has. 100 to 1600% (in 100 increments)
SMPTE ST 2084: Sets the dynamic range to be displayed from 0.005 to 10,000 nit that "SMPTE ST
2084" has.
100 to 4000 (2000) nit (in 100 increments)
 Setting procedures
The procedures below use Canon Log (HDR) as an example.
When the maximum value (800%) is specified, the 800% dynamic range of Canon Log is assigned
to the dynamic range of the video display. Although the brightness in appearance lowers, you can
check the dynamic range included in video signals. When 400% is specified, part exceeding 400%
is clipped (gradation is saturated) and part up to 400% is assigned to the dynamic range of the video
display.
This is the same for Canon Log 2 (HDR).
"SMPTE ST 2084" has the dynamic range of 0.005 to 10,000 nit. Therefore, when the maximum
value (4000 nit) is specified, part exceeding 4000 nit is clipped and part up to 4000 nit is assigned
to the dynamic range of the video display. Although the brightness in appearance lowers, you can
check the dynamic range up to 4000 nit. When 1000 nit is specified, part exceeding 1000 nit is
clipped and part up to 1000 nit is assigned to the dynamic range of the video display.
The brightness of the video display corresponds to the value set for Contrast.
Canon Log (HDR): Set to 800
Canon Log
range
800%
Gradation is reproduced by assigning
the range to the range of the DP-V2410
(which lowers the brightness).
400%
Sets whether or not to apply IDT (Input Device Transform) to "3G-SDI RAW" signals (
"Picture Mode" is set to "Canon Log" and "ACESproxy" is selected for "Color Gamut" or when
"ACESproxy" is selected for "Picture Mode".
Automatic: Applied automatically.
Off: Not applied.
This is displayed instead of Gamma and Color Gamut when "Picture Mode" is set to "Canon Log"
and "ACESproxy" is selected for "Color Gamut" or when "ACESproxy" is selected for "Picture
Mode".
ITU-R BT.709, ITU-R BT.2020, DCI-P3: ACESproxy is converted into respective mode.
Canon Log 800% signal
(Contrast: 4000)
Canon Log
DP-V2410
range
range
Canon Log (HDR): Set to 400
DP-V2410
range
800%
Clip (Saturates
gradation.)
400% 400%
OSD Menu
Brightness
value
corresponding
to the contrast
setting
43) when
37