Based-On Interface-Ip-Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

based-on interface-ip-address

based-on interface-ip-address IP-ADDRESS
no based-on interface-ip-address IP-ADDRESS
Syntax Description
IP-ADDRESS
Default
Command Mode
Usage Guideline
Examples
switch(config)#ip dhcp pool pool1
switch(config-dhcp)#based-on interface-ip-address 172.19.10.100
CLI Reference Guide
This command is used to specify a rule for a DHCP address pool to respond to a
request from the specified IP interface. Use the no form of the command to
remove the rule from the DHCP address pool.
Specifies the IP address of the interface.
None
DHCP pool configuration
An additional rule can be set for a DHCP address pool based on interface IP
address.
All of the DHCP IP address assignment rules take effect on the corresponding
DHCP address pool. A based-on command will be combined using logical AND
operations with the other rules set by all other based-on commands.
The following example sets a rule used for the IP address assignment (DHCP IP
address pool1) based on interface 172.19.10.100.
based-on interface-ip-address
61