Ip Ospf Retransmit-Interval - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip ospf retransmit-interval

ip ospf retransmit-interval SECONDS
no ip ospf retransmit-interval
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf retransmit interval 10
CLI Reference Guide
Use this command to specify the time between link-state advertisement (LSA)
retransmissions for adjacencies belonging to the interface. The no form of this
command will reset the retransmit-interval to the default value.
Specifies the interval in seconds. The range is 1 to 65535.
5 seconds
Interface configuration
After sending an LSA to a neighbor, the router keeps the LSA until it receives an
acknowledgement. In case the router does not receive an acknowledgement
during the set time (the retransmit interval value) it retransmits the LSA. Set the
retransmission interval value conservatively to avoid needless retransmission.
The interval should be greater than the expected round-trip delay between two
routers.
The following example shows setting the ospf retransmit interval to 10 seconds
on sVLAN 1 interface
Verfiy the settings by entering the show ip ospf interface command
ip ospf retransmit-interval
283