Show Ip Interface - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip interface

show ip interface [INTERFAC E-ID ] [brief]
Syntax Description
INTERFACE-ID
brief
Default
Command Mode
Usage Guideline
Example
Switch> show ip interface brief
Interface
--------------------------------------------------------------
vlan1
vlan2
Total Entires: 2
Switch>
CLI Reference Guide
Use this command to display the information of ip interfaces.
(Optional) Interface type and number. It refers to an IP interface, that is VLAN
interfaces only.
(Optional) Displays a summary of the usability status information for each
interface.
None
User EXEC or any configuration mode
An IP interface can be in either the down state or up state. When an interface is
in the up state, it can send and receive packets. If an interface is in the down
state, the directly connected routing entry is removed from the routing table.
Removing the entry allows the switch to use dynamic routing protocols to
determine backup routes to the network.
If an optional interface type is specified, then information for that specific
interface is displayed. This command only supports VLAN interface types.
If no optional arguments are specified, then information for all the interfaces is
displayed.
If the interface hardware is usable, the interface is marked "up." For an interface
to be usable, both the interface hardware and line protocol must be up.
This example shows how to display the brief format of the show ip interface
command.
IP-Address
10.90.90.90
20.1.1.1
Status
up
up
show ip interface
Protocol
up
up
632