DGS-6604
m
gvrp timer
gvrp timer { join | leave | leave-all } TIMER-VALUE
Syntax Description
join
leave
leave-all
TIMER-VALUE
<1-65535>
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-if)# gvrp timer leave-all 500
CLI Reference Guide
Use the gvrp timer command to set the GVRP timer value for a port.
Set the timer for joining the group. The unit is hundredths of a second.
Set the timer for leaving a group. The unit is hundredths of a second.
Set the time for leaving all groups. The unit is hundredths of a second.
The timer value in hundredths of a second.
join: 20
leave : 60
leave-all : 1000
Interface configuration
The value of these parameters must comply to the following rules:
1.
LEAVE_TIMER >= 3 * JOIN_TIMER
2.
LEAVE_ALL_TIMER > LEAVE_TIMER
This example shows how to set the leave-all timer to 5 seconds using the value
500 (hundredths of a second).
Verify the settings by entering the show gvrp configuration interface command.
gvrp timer
205