Cisco TelePresence MX800 Single Replacement Manual page 4

Cisco TelePresence MX800 Single
Contents
Products covered in this guide
• Cisco TelePresence MX800 Single.
MX800 Single comes with two camera versions:
Single camera and Dual camera. For both
versions, there are three mounting options: Free
standing floor stand, Floor stand secured to the
wall, and Wall mount
D15298.01 MX800 Single Replacement Guide, MARCH 2015.
Introduction Introduction Grilles and covers
About this guide
This guide describes how to replace spare parts for
MX800 Single.
The guide describes the steps required to remove
the parts. In order to install the replacement part, you
should follow the same steps in reverse order.
In addition to this Replacement guide, the following
documents are particularly useful when replacing parts.
• Cable schema
• Spare parts overview
• Installation guide(s)
These documents are available at the Cisco web site.
Go to http://www.cisco.com/go/mx-docs
Maintain and Operate Guides or Install and Upgrade
Guides.
Speakers and cameras
Ordering information
To place an order, please contact your local Cisco
representative or Cisco partner and refer to part
numbers as listed in this document.
Note that you cannot upgrade a single camera system
to a dual camera system by ordering spare parts; you
must order a complete system.
Cisco service and support
Cisco and our partners provide a broad portfolio
of smart, personalized services and support. For
more information about these services, go to:
http://www.cisco.com/go/telepresenceservices
and select
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
4
Replacement Guide
Codec and monitor Appendix